In the command prompt window type "exit" to close it.ģ1. Set the "Mask" fields in the Carrara 8 Pro preferences dialog to the same numbers as seen in the "Subnet Mask" from the ipconfig output.ģ0.
Set the "ID" fields in the Carrara 8 Pro preferences dialog to the same numbers as seen in the "IP Address" from the ipconfig output.Ģ9. In the dialog, type "cmd" to open a command prompt window.Ģ8. Click the Start menu and then select "Run"Ģ6. In the group "Network Rendering," set Sub Net to "Manual."Ģ5. Select "Render Room" from the drop down list.Ģ4. In this case, the master Carrara 8 Pro application needs to be told which network to use.Ģ3. This should only be required if your network consists of multiple network interfaces (such as a wired and wireless connection). If no grey "N" tiles are visible in the render window you need to configure the Sub Net manually. Only follow stepsĢ1 through 32 if you saw no grey "N" tiles during the render.Ģ1. If the render window and grey tiles appeared, there is no need to go further. Grey tiles with an N represent the areas that are being handled by a Render Node. Switch to the Output tab and Click "Set File Name" so that the resulting render is saved where desired.Ģ0. In the properties tray, Rendering tab, Miscellaneous section (at the bottom of the properties tray, often requires scrolling down to see it) verify that "Enable Network Rendering" is check marked.ġ8. Select the Carrara file to be rendered.ġ7. Switch to the Batch Queue tab in the tray at the bottom of the screen (tabs are located along the left hand side).ġ6. Click OK to accept those settings and close the Preferences dialog.ġ4. In the group "Network Rendering" verify that "Port1" is the same number as "Port1" from step 6.3.ġ2.
Select "Render Room" from the drop down list.ġ0. Go to the computer that was selected to be the Master and launch the Carrara 8 Pro application from the start menu.ĩ. Select "Application" from the drop down menu in the Preferences dialog.Ħ.3 Verify that all running Render Node applications show the same number for "Port1:" By default this is 5020.Ħ.4 Click OK to close the preferences dialog.ħ. For each Render Node application that is runningĦ.2. Launch the Render Node application from the Start Menu on all computers that were selected to be Render Nodes.Ħ. Decide which computers will be used as Render Nodes.ĥ. Boot up all computers that will be used for the render.ģ. Shut down all computers that will be used for the render (this isn't really necessary, but makes giving the directions more clear, I hope).Ģ.
0 kommentar(er)
